RE-1SS

• Striking appearance in any setting.

• Two general purpose relays for maximum system functionality.

• Built-in wireless Mega Code radio and antenna.

• Voice prompts. User and owner friendly.

• Full-featured telephone with intercom modes.

• Easy to install and program.

• Capacity for 100 entry codes for commercial sites.

• download brochure
  download manual

GENERAL SPECIFICATIONS:

OUTPUTS:

Relay: Two form “C “ relays rated at 3A @ 30 Vac or Vdc. Each programmable for control, obstacle, alarm or shunt.
Sounder: Programmable for key presses and relay activation.
Voice: Synthesized human voice prompts for visitor and programming assistance. Voice is heard through speaker and remote telephones.

INPUTS:

RF: integral 318 MHz super heterodyne receiver @ -100dBm sensitivity (typical); receives Linear block coded transmitters and MGT supervised reversing edge transmitters
Open Request: terminal input for each relay; when activated, will trigger the assigned relay for the programmed relay on time
Door Sense/Inhibit: terminal input for each relay monitors status of a protected entry point or can be programmed to restrict access to the assigned relay
Keypad: 12 digit telephone style keypad for accepting entry codes and for local programming
Power: 16 Vac (transformer included); input for externally charged 12 to 24 Vdc battery backup
Current Draw (dialing out to one phone): 16 Vac: 270 mA standby, 440 mA operating, 12 Vdc: 250 mA standby, 500 mA operating, 24 Vdc 150 mA standby, 300 mA operating 16 Vac: 270 mA standby, 440 mA operating, 12 Vdc: 250 mA standby, 500 mA operating, 24 Vdc 150 mA standby, 300 mA operating
Operating Temperature: -22°F to 149°F (-30°C to 65°C)

PROGRAMMING:

Programming: Locally via keypad; remotely via touchtone telephone phone or computer with modem running a web browser. NO SOFTWARE REQUIRED
Memory: All data memory is stored in non volatile EEPROM with data retention in excess of 10 years
Clock/Calendar: 24/7 clock/calendar with battery backup used for time zones; relay hold open times; date/time stamp for event log entries; down light on/off times
Connections: All power, telephone, relay and control connections to the unit are with plug on screw terminal blocks; RJ-45 and BNC connections for optional RE-BWC camera kit

PROGRAMMING:

Programming: Locally via keypad; remotely via touchtone telephone phone or computer with modem running a web browser. NO SOFTWARE REQUIRED
Memory: All data memory is stored in non volatile EEPROM with data retention in excess of 10 years
Clock/Calendar: 24/7 clock/calendar with battery backup used for time zones; relay hold open times; date/time stamp for event log entries; down light on/off times
Connections: All power, telephone, relay and control connections to the unit are with plug on screw terminal blocks; RJ-45 and BNC connections for optional RE-BWC camera kit